Drill patterns for Marker bindings

[KevinF]

I have some DPS Wailer 99's that currently have Marker Griffon bindings on them. I was thinking of pulling the Griffon's off and putting the Marker Tour F12 on instead.

Is the mounting drill pattern the same between the F12's and the Griffon's? i.e., pull one off, put the other one on, no need to drill again, etc.?

 

[Philpug]

It is a different pattern.

 

[KevinF]

It is a different pattern.

Ok, thanks... Is it still safe to re-drill or will the holes be right next to each other?

 

[Philpug]

Ok, thanks... Is it still safe to re-drill or will the holes be right next to each other?

As long as there is visable top sheet between the holes...3/16" or so.

 

[SlideWright]

Here's a Baron/Duke template that IIRC uses the same hole pattern (pre EPF). If other alpine binding templates are need, check here.

Print it without scaling, check scale and see how the holes compare.

 

[John Webb]

I just fake it with binding mounts. Never used a jig. Sure it takes 4 times longer but have had no problems.