Featured Sneak Peek: 2019 K2 Recon Ski Boot

Discussion in 'Ski Boot Discussion by America's Best Bootfitters' started by Philpug, Jan 23, 2018.

  1. Philpug

    Philpug The season is over when we say it's over. Admin Pugski Ski Tester

    Joined:
    Nov 1, 2015
    Posts:
    15,531
    Location:
    Reno, eNVy
    Screen Shot 2018-01-23 at 7.34.45 AM.png

    For 2019, K2 will be offering an entirely new boot collection with a blast from the past named the Recon. First of all, “all new” gets thrown around a lot. The Recons are not Spynes with NGT (New Graphics Technology); they are a ground-up redesign starting with slightly shorter BSLs to completely new plastics that shave ... err … chop hundreds of grams from the previous collection, down to about 1650g in the reference 26.5 shell size.

    IMG_2211.JPG IMG_2212.JPG IMG_2213.JPG fullsizeoutput_6acb.jpeg IMG_2215.JPG IMG_2216.JPG

    One of my toughest jobs as a tester is reviewing early-production ski boots because most are produced in the more common sizes of 26.5 or 27.5, and I normally ski in a low-volume 25.5. K2 sent the Recon 120 in a 26.5 medium-volume 100mm shell, so what am I to do? Simple, build a footbed to take up that excess volume. I also added a Bontex shim between the liner and the zeppa before heading out to Mt Rose.

    IMG_2224.JPG IMG_2225.JPG IMG_2226.JPG
    While this process worked well in the initial shop fit, once I was on the slopes, it was actually taking up too much volume so I had to remove the shim. Why am I even pointing this out? Well, I took the boot off at the top of the lift on the bench where snowboarders strap in. That may not sound like a monumental feat, but it is something that I could never have done in a traditional plastic boot. This lightweight boot was easy to get off and back on even in the cold. I don't expect everyone to do this, but there has been a lot of talk of some of these newer plastics being difficult to get off when cold; this is not the case with the new K2 Recon.

    With the extra shim out, it was time to ski. I have skied 100mm boots before, even in a 25.5, and it really is an act of futility, because I just swim in it. Sure it's fine just “standing on the boot” on groomers, but as soon as I go into other conditions, my foot just starts moving and I have no control, especially in moguls and other varied terrain. The Recon actually skied quite well in the mixed conditions with a level of control that was a pleasant surprise.

    IMG_2229.JPG

    K2 chose to stay with a more upright stance in the new Recon with a 4° ramp and a 12° cuff angle adjustment; using the heat-moldable shell and adding a spoiler, the cuff angle can be molded from 10° to 16°. I have been skiing in the Head Raptor 140, which is much more aggressive out of the box, but I didn’t feel too upright in the Recon (with the supplied spoiler), and the 120 flex allowed me to drive the boot easily.
    IMG_2227.JPG

    IMG_2222.JPG
    The Recon and its sister Luv series will be offered in the expected flex and width ranges; certain models will also have heated versions. They will be both GripWalk-compatible and Cantology-friendly, which will make your local bootfitter happy. We will be passing the boot along to one of our testers who skis this size shell; stay tuned for a full long-term test.
    Models in the collection:
    • Men (24.5-30.5)
      • Recon 130 LV/MV
      • Recon 120 LV/MV
      • Recon 120 Heat MV
      • Recon 100 MV
    • Women (22.5-27.5)
      • Luv 110 LV/MV
      • Luv 100 LV/MV
      • Luv 100 Heat MV
      • Luv 80 LV/MV
    LV = 98mm
    MV = 100mm​
     
    Last edited: Jan 23, 2018
    NESkier_26, 1chris5 and Ron like this.
  2. Andy Mink

    Andy Mink I am a half fast skier. Moderator Pugski Ski Tester

    Joined:
    Nov 12, 2015
    Posts:
    913
    Location:
    Reno
    Ya gotta do what ya gotta do.
    20180121_093008-1.jpg
     
    laine, Ron, Slim and 1 other person like this.
  3. Ken_R

    Ken_R Living the Dream Skier

    Joined:
    Feb 10, 2016
    Posts:
    1,636
    Location:
    Littleton, CO
    Philpug likes this.
  4. PTskier

    PTskier Been goin' downhill for years.... Skier

    Joined:
    Jun 16, 2017
    Posts:
    581
    Location:
    Washington, the state
    Are these boots from Dalbello or Full Tilt? All the same ownership, K2-MDV Holdings, L.P., part of Kohlberg & Co. (MDV = Marker, Dalbello, Volkl)
     
  5. Philpug

    Philpug The season is over when we say it's over. Admin Pugski Ski Tester

    Joined:
    Nov 1, 2015
    Posts:
    15,531
    Location:
    Reno, eNVy
    I imagine they will come out of the shared factory. I do not see any parts or design elements shared with any current or upcoming products I have seen so far.
     


  6. Brian Finch

    Brian Finch PT, CSCS, Cert- DN, FRCms, M|WOD Coach Industry Insider

    Joined:
    Nov 17, 2015
    Posts:
    1,190
    Location:
    Vermont
    @Philpug you had me until “upright stance”.

    :snowball:
     
    James likes this.
  7. Philpug

    Philpug The season is over when we say it's over. Admin Pugski Ski Tester

    Joined:
    Nov 1, 2015
    Posts:
    15,531
    Location:
    Reno, eNVy
    But can be heat molded to 16*
    :snowball:
     
  8. Miller

    Miller Booting up Skier

    Joined:
    Feb 3, 2016
    Posts:
    12
    How would you describe the heel pocket on this boot.
     
    neonorchid likes this.
  9. Philpug

    Philpug The season is over when we say it's over. Admin Pugski Ski Tester

    Joined:
    Nov 1, 2015
    Posts:
    15,531
    Location:
    Reno, eNVy
    Pretty darn good for a 100mm shell. Like I said, I normally ski in a 96-97mm and other 100mm shells that I have attempted to ski I would move around in (especially the back half of the boot), I had sufficient control with the Recon.
     
    Brian Finch and neonorchid like this.
  10. Ron

    Ron AKA Finndog Pugski Ski Tester

    Joined:
    Nov 8, 2015
    Posts:
    3,773
    Location:
    Steamboat Springs, Co
    Phil handed these off to me for further testing especially since I normally wear a Lange RX 130 LV (98mm) in 26.5 with a BSL (boot sole length) of 306. The K2's are 304. For reference, I am 10.5 in a street shoe. I have not had these heat molded yet (hopefully, next week) but My overall impression after putting in my beds are that although its a 100mm boot, the overall fit is pretty low volume. It def' has a lower instep than the Lange and I am really loving the achilles and heel grip which actually feels tighter than the Lange. After having them on my feet for over an hour I can really notice the lightness of the boot. I am going to ski them tomorrow since they fit so well. i had to adjust the cuffs for better alignment but otherwise, I really like the out of the box fit. You can't tell at Room temperature but the plastic does feel more pliable than my langes.
     
    Last edited: Feb 7, 2018
    Tricia and Philpug like this.
  11. Ron

    Ron AKA Finndog Pugski Ski Tester

    Joined:
    Nov 8, 2015
    Posts:
    3,773
    Location:
    Steamboat Springs, Co
    Quick update. I skied the Recons today and was quite happy with this boot. I need to compare some numbers but the boot had a very good feel of being connected to the ski. Although flex is relative, I felt the 120 was more like a 130 in a good way. Most liked so far: after a couple of hours in the cold temps, this boot came off like a regular shoe.
     
    Last edited: Feb 5, 2018
    Brian Finch and Tricia like this.
  12. Ron

    Ron AKA Finndog Pugski Ski Tester

    Joined:
    Nov 8, 2015
    Posts:
    3,773
    Location:
    Steamboat Springs, Co
    @Brian Finch I skied with the spoilers in today and really liked the setup. This is a boot more people should be paying attention to. Write up coming soon but the 120 MAP is 499! I am liking this boot more than my Lange...... :popcorn:
     
    Last edited by a moderator: Feb 7, 2018
  13. Brian Finch

    Brian Finch PT, CSCS, Cert- DN, FRCms, M|WOD Coach Industry Insider

    Joined:
    Nov 17, 2015
    Posts:
    1,190
    Location:
    Vermont
    5444EE80-52CF-4015-B016-F5BEC5F2595A.jpeg
    Spoilers FTW!
     
    Ron likes this.
  14. Philpug

    Philpug The season is over when we say it's over. Admin Pugski Ski Tester

    Joined:
    Nov 1, 2015
    Posts:
    15,531
    Location:
    Reno, eNVy
    SPOILER ALERT!
     
    Tricia and Ron like this.
  15. Ske-Bum

    Ske-Bum At the base lodge Skier

    Joined:
    Feb 14, 2016
    Posts:
    5
    Location:
    Tahoe City, CA
    Good review, however if you don’t fit in the boot why not wait to review it until you can get the correct size, seems like that would make life easier and the review more valid. Also did I read that correctly, your every day boot is a 140? Are you running a GS everyday?
     
  16. Ron

    Ron AKA Finndog Pugski Ski Tester

    Joined:
    Nov 8, 2015
    Posts:
    3,773
    Location:
    Steamboat Springs, Co
    Thats why he gave it to me to demo
     
  17. Ske-Bum

    Ske-Bum At the base lodge Skier

    Joined:
    Feb 14, 2016
    Posts:
    5
    Location:
    Tahoe City, CA
    Yes, it seems he did, after the fact though.
     
  18. Philpug

    Philpug The season is over when we say it's over. Admin Pugski Ski Tester

    Joined:
    Nov 1, 2015
    Posts:
    15,531
    Location:
    Reno, eNVy
    Again, the post was a preview, not a review. 25.5 shells will not be available until next season, at that point, I am sure I will get one in my size. The Head Raptor is listed as a 140, that is if you put the additional bolts in the cuff, but I am not using the additional bolts, so the boot is more like a 130 as I am using it.
     
  19. Ske-Bum

    Ske-Bum At the base lodge Skier

    Joined:
    Feb 14, 2016
    Posts:
    5
    Location:
    Tahoe City, CA
    Ok, makes sense now, on both boots.
     
    Philpug likes this.
  20. Snowfan

    Snowfan Out on the slopes Skier

    Joined:
    Oct 23, 2016
    Posts:
    447
    Location:
    Bugbee, Texas

Share This Page


We respect your privacy. your information is safe and will never be shared