About to install a set on a marker piston plate. This is my first time installing a binding, so a few questions:
1. Do I need to adjust the toe piece hieght for the AFD? Not seeing any way to and haven't seen it mentioned anywhere.
2. What should I torque the screws to as I attach them to the piston plate?
3. After I have installed the binding/adjusted din/adjusted forward pressure - anything else I need to do or am I safe to ski? Debating if a release check at a shop is needed.
Thanks!
1. Do I need to adjust the toe piece hieght for the AFD? Not seeing any way to and haven't seen it mentioned anywhere.
2. What should I torque the screws to as I attach them to the piston plate?
3. After I have installed the binding/adjusted din/adjusted forward pressure - anything else I need to do or am I safe to ski? Debating if a release check at a shop is needed.
Thanks!