Marker piston plate - Blizzard WRC

[Thomas Norway]

Hello,

Just bought a pair of Blizzard WRC with the Marker piston plate mounted on them. Now I'm going to mount the bindings (X-cell) and wondering if anyone have an idea where the center mark of the skis are (to be more precise; where on the plate the center are).

Just want to be assured that the bindings are correct mounted.

Thomas

 

[BGreen]

What is your boot sole length?

 

[markojp]

If I recall, in the plate info, there should be instructions on which holes to use according to your bsl.

 

[Thomas Norway]

What is your boot sole length?

Thanks - sole length is 326.

I believe I have found the correct mounting manual (the one I used was an old one and the holes didn't match the plate) so I'll try to sort this out.

 

[markojp]

Great skis btw... you'll enjoy them immensely.

 

[ScotsSkier]

From the tech manual you should use the rearmost set of holes for the toe and the heel for a 326 BSL. Personally I would use the middle hole for the toe and the second to rear for the heel. Easy to change if you want to move it back

 

[Thomas Norway]

All,

Many tanks for relevant feedback - very much appreciated.

 

[Erik Timmerman]

The plate is marked for Comp bindings, use the same holes for the heel, and the toe is offset by one hole.

 

[Cheizz]

Have a look at page 78 in this PDF manual: www.markercertification.com/downloads/1617_Marker_Tec_Manual.pdf

I mounten an XCell binding recently by direction of this document. Easy.